Workshop Repair Manuals

Jeep Workshop Manuals

[PREV PAGE] [NEXT PAGE]

jeep Workshop Repair Guides


Grand Cherokee 2WD V6-3.7L (2008)

Powertrain Management > Computers and Control Systems > Crankshaft Position Sensor > Component Information > Service and Repair > Crankshaft Position Sensor - Removal > Page 3653

Page 1
background image

Crankshaft Position Sensor: Service and Repair
Crankshaft Position Sensor - Installation

3.7L

1. Clean out machined hole in engine block.
2. Apply a small amount of engine oil to sensor o-ring.
3. Install sensor (3) into engine block with a slight rocking and twisting action.

CAUTION: Before tightening sensor mounting bolt, be sure sensor is completely flush to cylinder block. If sensor is not flush, damage to
sensor mounting tang may result.

4. Install mounting bolt (1) tighten to 28 Nm (21 ft. lbs.) torque.
5. Connect electrical connector to sensor.
6. Lower vehicle.

Powertrain Management > Computers and Control Systems > Crankshaft Position Sensor > Component Information > Service and Repair > Crankshaft Position Sensor - Removal > Page 3653

[PREV PAGE] [NEXT PAGE]