Jeep Workshop Manuals
Grand Cherokee 2WD V6-3.7L (2008)
Powertrain Management > Computers and Control Systems > Sensors and Switches - Computers and Control Systems > Camshaft Position Sensor > Component Information > Service and Repair > Camshaft Position Sensor - Removal > Page 4062
Camshaft Position Sensor: Service and Repair
1. Clean out machined hole in cylinder head.
CAUTION: Before tightening sensor mounting bolt, be sure sensor is completely flush to cylinder head. If sensor is not flush, damage to
4. Install mounting bolt (2) and tighten to 12 Nm (106 in. lbs.).
|[PREV PAGE] [NEXT PAGE]|