Jeep Workshop Manuals
Grand Cherokee 2WD V6-3.7L (2008)
Powertrain Management > Computers and Control Systems > Sensors and Switches - Computers and Control Systems > Fuel Level Sensor > Component Information > Service and Repair > Fuel Pump Module - Removal > Page 4128
Fuel Level Sensor: Service and Repair
CAUTION: Whenever the fuel pump module is serviced, the rubber seal (gasket) must be replaced.
1. Using a new seal (gasket), position fuel pump module into opening in fuel tank.
of fuel tank. Also be sure fuel fitting on top of pump module is pointed to drivers side of vehicle.
4. Install Lockring Remover/Installer 9340 (3) to lockring.
|[PREV PAGE] [NEXT PAGE]|