Workshop Repair Manuals

Jeep Workshop Manuals

[PREV PAGE] [NEXT PAGE]

jeep Workshop Repair Guides


Grand Cherokee 2WD V6-3.7L (2008)

Relays and Modules > Relays and Modules - Power and Ground Distribution > Power Distribution Module > Component Information > Technical Service Bulletins > All Technical Service Bulletins for Power Distribution Module: > H03 > Feb > 08 > Recall - Front Control. Module Inspection/Replacement > Page 350

Page 5
background image

>

If the Julian date code is 337, 338, or 339 the FCM must be replaced. Continue with Step 3 of this procedure. 

4.

Disconnect the two IPM electrical connectors (Figure 3).

5.

Disconnect the two FCM electrical connectors (Figure 3).

6.

Remove the IPM assembly from the vehicle.

7.

Remove the four fasteners securing the FCM to the IPM (Figure 4).

8.

Separate the original FCM from the IPM by pulling the two straight away from each other to disengage the electrical connector (Figure 5).

9.

Transfer the plastic cover from the original FCM module to the new FCM module (Figure 4).

10.

Connect the new FCM to the IPM by lining up the electrical connector and pushing the two modules together (Figure 5).

Relays and Modules > Relays and Modules - Power and Ground Distribution > Power Distribution Module > Component Information > Technical Service Bulletins > All Technical Service Bulletins for Power Distribution Module: > H03 > Feb > 08 > Recall - Front Control. Module Inspection/Replacement > Page 350

[PREV PAGE] [NEXT PAGE]