Jeep Workshop Manuals
Grand Cherokee 2WD V6-3.7L (2008)
Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Computers and Control Systems > Engine Control Module > Component Information > Testing and Inspection > SKREEM Programming > Page 521
3. Select "ECU View".
NOTE: If the ECM and the SKIM are replaced at the same time, all vehicle keys will need to be replaced and programmed to the new
PROGRAMMING IGNITION KEYS TO THE SKREEM
Each ignition key transponder also has a unique ID code that is assigned at the time the key is manufactured. When a key is programmed into the
NOTE: If the original keys do not successfully program to the new SKREEM after the proper procedures are followed correctly, programming
NOTE: A maximum of eight keys can be learned to each SKREEM. Once a key is learned to a SKREEM, that key has acquired the Secret Key
If ignition key programming is unsuccessful, the scan tool will display one of the following error messages:
PROGRAMMING NOT ATTEMPTED - The scan tool attempts to read the programmed key status and there are no keys programmed into
PROGRAMMING KEY FAILED (POSSIBLE USED KEY FROM WRONG VEHICLE) - SKREEM is unable to program an ignition key
The ignition key transponder is ineffective.
The ignition key transponder is or has been already programmed to another vehicle.
8 KEYS ALREADY LEARNED, PROGRAMMING NOT DONE - The SKREEM transponder ID memory is full.
LEARNED KEY IN IGNITION - The ID for the ignition key transponder currently in the ignition lock cylinder is already programmed into
|[PREV PAGE] [NEXT PAGE]|