Workshop Repair Manuals

Jeep Workshop Manuals

[PREV PAGE] [NEXT PAGE]

jeep Workshop Repair Guides


Grand Cherokee 2WD V6-3.7L (2008)

Relays and Modules > Relays and Modules - Transmission and Drivetrain > Relays and Modules - A/T > Control Module, A/T > Component Information > Technical Service Bulletins > Customer Interest for Control Module: > 18-007-10 > Mar > 10 > Engine Controls - MIL ON/DTC's P0730/P0731 > Page 676

Page 2
background image

The flash update is a combination flash that will update both the PCM and TCM controllers.

NOTE:

If this flash process is interrupted/aborted, the flash should be restarted.

1. Reprogram the PCM/TCM with the latest software. Follow the detailed service procedures available in DealerCONNECT/TechCONNECT, Refer

To Group 8 - Electrical > Electronic Control Modules - Service Information > Module - Powertrain Control > Standard Procedures > PCM/ECM
Programming - Gas. After PCM reprogramming, the following must be performed:

a. Clear any DTC's that may have been set in other modules due to reprogramming. The wiTECH application will automatically present all DTCs

after the flash and allow the tech to clear them.

2. Type the necessary information on the "Authorized Modification Label" and attach it near the VECI label.

POLICY:
Reimbursable within the provisions of the warranty.

TIME ALLOWANCE:

FAILURE CODE:

Disclaimer:

This bulletin is supplied as technical information only and is not an authorization for repair.

Relays and Modules > Relays and Modules - Transmission and Drivetrain > Relays and Modules - A/T > Control Module, A/T > Component Information > Technical Service Bulletins > Customer Interest for Control Module: > 18-007-10 > Mar > 10 > Engine Controls - MIL ON/DTC's P0730/P0731 > Page 676

[PREV PAGE] [NEXT PAGE]