Grand Cherokee 2WD V6-3.7L (2008)
Parking Assist Distance Sensor: Service and Repair
Park Assist Sensor - Removal
Front
FRONT
NOTE: The park assist sensors (3) and the sensor spacers (2) are each available for separate service replacement. The sensor brackets (1) are
bonded and integral to the back side of the front bumper fascia (4).
1. Disconnect and isolate the battery negative cable.
2. Remove the bumper fascia from the front of the vehicle. See: Body and Frame/Bumper/Front Bumper/Front Bumper Cover / Fascia/Service and
Repair/Front Fascia - Removal.
3. From the back of the fascia (4), disconnect the wire harness connector from the park assist sensor (3) connector receptacle.
4. Carefully pry the sensor bracket (1) latch features away from the top and bottom tabs of the sensor far enough to disengage the sensor from the
bracket.
5. Disengage the O-ring spacer (2) from around the circumference of the sensor membrane protrusion.
Rear
REAR
NOTE: The park assist sensors, the sensor spacers and the sensor brackets are each available for separate service replacement. The following
service procedure can be used for disassembling any or all of these components from the rear bumper fascia.
1. Disconnect and isolate the battery negative cable.
2. Remove the bumper fascia from the rear of the vehicle. See: Body and Frame/Bumper/Rear Bumper/Rear Bumper Cover / Fascia/Service and
Repair/Rear Fascia - Removal.
3. From the back of the fascia, disconnect the wire harness connector from the park assist sensor connector receptacle (1).
4. If only the sensor or the sensor spacer are being replaced, carefully pry the sensor bracket latch features (2) away from the top and bottom tabs of