Workshop Repair Manuals

Jeep Workshop Manuals

[PREV PAGE] [NEXT PAGE]

jeep Workshop Repair Guides


Grand Cherokee 2WD V6-3.7L (2008)

Sensors and Switches > Sensors and Switches - Body and Frame > Trunk / Liftgate Ajar Switch > Component Information > Technical Service Bulletins > All Technical Service Bulletins for Trunk / Liftgate Ajar Switch: > 08-022-07 > Sep > 07 > Electrical - Courtesy Lamps ON/Liftgate Ajar Message > Page 967

Page 2
background image

NOTE

Cavity numbers are stamped on the connector.

3.

Measure the voltage at cavity 1 of the 2-way liftgate ajar switch connector.

4.

Is the voltage above 10 volts?

a.

Yes >> Further diagnosis is required, this service bulletin does not apply.

b.

No >> Proceed to Step # 5

5.

Turn ignition key off.

6.

Swap wires in the 2-way liftgate ajar switch connector. Cavity 1 should contain the "G78 - liftgate ajar switch sense circuit and cavity 2 should
contain the "Ground circuit.

POLICY:
Reimbursable within the provisions of the warranty.

TIME ALLOWANCE:

FAILURE CODE:

Disclaimer:

This bulletin is supplied as technical information only and is not an authorization for repair.

Sensors and Switches > Sensors and Switches - Body and Frame > Trunk / Liftgate Ajar Switch > Component Information > Technical Service Bulletins > All Technical Service Bulletins for Trunk / Liftgate Ajar Switch: > 08-022-07 > Sep > 07 > Electrical - Courtesy Lamps ON/Liftgate Ajar Message > Page 967

[PREV PAGE] [NEXT PAGE]