Workshop Repair Manuals

Jeep Workshop Manuals

[PREV PAGE] [NEXT PAGE]

jeep Workshop Repair Guides


Grand Cherokee 2WD V6-3.7L (2008)

Sensors and Switches > Sensors and Switches - Starting and Charging > Ignition Switch > Ignition Switch Lock Cylinder > Component Information > Service and Repair > Removal

Page 1
background image

Ignition Switch Lock Cylinder: Service and Repair
Removal

REMOVAL

The key lock cylinder may be removed without removing the switch assembly, although the original ignition key must be used.

1. Disconnect negative cable from battery.
2. Use a plastic trim removal stick (2) to remove switch bezel (1). Bezel snaps on.

3. To remove key lock cylinder (1) from housing (2), rotate key to ON position while pressing on release tab (3). This tab (3) is located on the right

side of the switch assembly.

Sensors and Switches > Sensors and Switches - Starting and Charging > Ignition Switch > Ignition Switch Lock Cylinder > Component Information > Service and Repair > Removal

[PREV PAGE] [NEXT PAGE]