Grand Cherokee 2WD V6-3.7L (2008)
harness (5) directly to the Steering Control Module (SCM), which is internal to the housing (2) of the left multi-function switch (1).
The right (wiper) multi-function switch provides the vehicle operator with a control interface for the following wiper and washer system functions:
-
Automatic Front Wipers - For vehicles so equipped, the right multi-function switch control knob provides detent switching for the optional
automatic front wipe mode with five minor detent sensitivity positions.
-
Continuous Front Wipers - The right multi-function switch control knob provides detent switching for two continuous front wipe modes, low
speed or high speed.
-
Intermittent Front Wipers - The right multi-function switch control knob provides detent switching for the intermittent front wipe mode with
five minor detent delay interval positions. On vehicles that have the optional automatic wiper system, the automatic front wipe positions of the
control knob provide default intermittent wipe mode operation whenever the automatic system has been disabled using the customer
programmable features option in the Electronic Vehicle Information Center (EVIC).
-
Front Wiper Mist Mode - The right multi-function switch control stalk includes momentary switching of the front wiper motor low speed circuit
to provide a mist mode features (sometimes referred to as pulse wipe), which allows the vehicle operator to momentarily operate the front wipers
for one or more complete cycles.
-
Front Washer Mode - The right multi-function switch control stalk provides momentary switching for control of the front washer system
operation.
-
Intermittent Rear Wipe Mode - The right multi-function switch control sleeve provides detent switching for a single fixed interval intermittent
rear wiper mode.
-
Rear Washer Mode - The right multi-function switch control sleeve provides two momentary switch positions for control of rear washer system
operation.
The right multi-function switch cannot be adjusted or repaired. If any function of the switch is ineffective, or if the switch is damaged, the entire switch
unit must be replaced. The clockspring (with the multi-function switch mounting bracket), the left multi-function switch (with the SCM), the right
multi-function switch and the jumper wire harness are each available for separate service replacement.
