Grand Cherokee 2WD V8-318 5.2L VIN Y MFI (1994)
8. Install overrunning clutch on hub. Note that clutch only fits one way. Shoulder on clutch should seat in small recess at edge of hub.
9. Install thrust bearing on overrunning clutch hub. Use generous amount of petroleum jelly to hold bearing in place for installation. Bearing fits one
way only. Be sure bearing is seated squarely against hub. Reinstall bearing if it does not seat squarely.
10. Install overrunning clutch in output shaft. Insert snap ring pliers in hub splines. Expand pliers to grip hub. Then install assembly with
counterclockwise, twisting motion.
11. Install planetary gear in annulus gear. Be sure planetary pinions are fully seated in annulus near before proceeding.
12. Coat planetary thrust bearing and bearing contact surface of spring plate with generous amount of petroleum jelly. This will help hold bearing in
place during installation.