Grand Cherokee 2WD V8-4.7L VIN J (2004)
Power Seat Motor: Testing and Inspection
RECLINER MOTOR
Actuate the power seat recliner switch to move the power seat recliner adjuster in each direction. The power seat recliner adjuster should move in both
directions. If the power seat recliner adjuster fails to operate in only one direction, move the adjuster a short distance in the opposite direction and test
again to be certain that the adjuster is not at its travel limit. If the power seat recliner adjuster still fails to operate in only one direction, refer to Power
Seat Switch Diagnosis and Testing in this group.
If the power recliner adjuster fails to operate in either direction, perform the following tests. For complete circuit diagrams, refer to Wiring Diagrams.
1. Check the power seat circuit breaker in the junction block. If OK, go to Step 2. If not OK, replace the faulty power seat circuit breaker.
2. Check for battery voltage at the power seat circuit breaker in the junction block. If OK, go to Step 3. If not OK, repair the open fused B(+) circuit
to the fuse in the Power Distribution Center as required.
3. Remove the outboard seat cushion side shield from the seat. Disconnect the seat wire harness connector from the power seat switch connector
receptacle. Check for battery voltage at the fused B(+) circuit cavity of the power seat wire harness connector for the power seat switch. If OK, go
to Step 4. If not OK, repair the open fused B(+) circuit to the power seat circuit breaker in the junction block as required.
4. Check for continuity between the ground circuit cavity of the power seat wire harness connector for the power seat switch and a good ground.
There should be continuity. If OK, go to Step 5. If not OK, repair the open ground circuit to ground as required.
5. Test the power seat switch. Refer to Power Seat Switch Diagnosis and Testing in this group. If the switch tests OK, test the circuits of the power
seat wire harness between the power seat recliner adjuster motor and the power seat switch for shorts or opens. If the circuits check OK, replace
the faulty power seat recliner unit If the circuits are not OK, repair the power seat wire harness as required.