Grand Cherokee 2WD V8-4.7L VIN J (2004)
26.
Attach the center of the seat cushion cover to the grid wire in the seat foam with the upholstery rings supplied in the kit (Figure 5).
NOTE:
The kit contains four extra upholstery rings.
27.
Pull the seat cover into position over the seat cushion foam.
28.
Turn the seat cushion upside down and connect the plastic "J" straps, and plastic clip.
29.
Connect the rear "J" strap to the seat frame.
30.
Install one upholstery ring on the front "J" strap in the same location as was removed earlier (Figure 3).
31.
The seat cushion is complete. Set the cushion aside.
32.
Place the seatback face-down on a clean work bench.
33.
Disconnect the "J" strap located on the bottom of the seatback (Figure 6).
34.
Partially pull the seatback cover inside out until half of the seatback foam is exposed.
35.
Carefully remove the old seat heating element. Discard the old element.
CAUTION:
