Grand Cherokee 2WD V8-4.7L VIN J (2004)
5.
Visually inspect the front brakes for any abnormalities and record the findings on the hard copy of the repair order.
6.
Repeat steps Step # 2 - Step # 5 for the other side of the vehicle.
7.
Install both front wheel and tire assemblies using the marks made in Step # 3. Torque the lug nuts in a criss-cross pattern to 14 Nm (10 ft. lbs.).
8.
Lower the vehicle.
9.
Using the same criss-cross pattern, final torque the lug nuts to 135 Nm (100 ft. lbs.).
10.
Advise the vehicle operator of the inspection results.
PROCEDURE B
1.
Drain small amount of fluid from master cylinder brake reservoir with clean suction gun.
2.
Raise the vehicle on a suitable hoist.
3.
Remove both front wheel and tire assemblies.
4.
Bottom caliper pistons into the caliper by prying the caliper over (Fig. 1).