Grand Cherokee 2WD V8-4.7L VIN J (2004)
2. Install new booster dash seal.
3. Align and position booster on engine compartment side of dash panel.
4. Inside passenger compartment:
a. Lubricate pedal pin Mopar multi-mileage grease.
b. Install booster attaching nuts on studs. Tighten attaching nuts to 39 Nm (29 ft. lbs.).
c. Slide booster push rod on pedal pin. Then secure rod to pin with retainer clip.
5. In engine compartment, attach vacuum hose to booster check valve.
6. Install the master cylinder with new gasket and nuts.
CAUTION: The master cylinder installation procedure must be perform as written or damage to the booster/master cylinder may occur.
7. Fill and bleed brake system.
