Grand Cherokee 2WD V8-4.7L VIN J (2004)
Rocker Arm Assembly: Service and Repair
ROCKER ARM / ADJUSTER ASSEMBLY
REMOVAL
NOTE: Disconnect the battery negative cable to prevent accidental starter engagement.
1. Remove the cylinder head cover.
2. For rocker arm removal on cylinders 3 and 5 Rotate the crankshaft until cylinder # 1 is at TDC exhaust stroke.
3. For rocker arm removal on cylinders 2 and 8 Rotate the crankshaft until cylinder # 1 is at TDC compression stroke.
4. For rocker arm removal on cylinders 4 and 6 Rotate the crankshaft until cylinder # 3 is at TDC compression stroke.
5. For rocker arm removal on cylinders 1 and 7 Rotate the crankshaft until cylinder # 2 is at TDC compression stroke.
6. Using special tool 8516 Rocker Arm Remover, press downward on the valve spring, remove rocker arm (Fig. 28).
INSTALLATION
CAUTION: Make sure the rocker arms are installed with the concave pocket over the lash adjusters. Failure to do so may cause severe damage to the
rocker arms and/or lash adjusters.
NOTE: Coat the rocker arms with clean engine oil prior to installation.
1. For rocker arm installation on cylinders 3 and 5 Rotate the crankshaft until cylinder # 1 is at TDC exhaust stroke.
2. For rocker arm installation on cylinders 2 and 8 Rotate the crankshaft until cylinder # 1 is at TDC compression stroke.
3. For rocker arm installation on cylinders 4 and 6 Rotate the crankshaft until cylinder # 3 is at TDC compression stroke.
4. For rocker arm installation on cylinders 1 and 7 Rotate the crankshaft until cylinder # 2 is at TDC compression stroke.
5. Using special tool 8516 press downward on the valve spring, install rocker arm (Fig. 28).
6. Install the cylinder head cover.