Grand Cherokee 2WD V8-4.7L VIN J (2004)
3. Place the strands of wire overlapping each other inside of the splice clip (Fig. 14).
Fig. 15 Crimping Tool
4. Using crimping tool, Mopar p/n 05019912AA, crimp the splice clip and wires together (Fig. 15).
Fig. 16 Solder Splice
5. Solder the connection together using rosin core type solder only (Fig. 16).
CAUTION: DO NOT USE ACID CORE SOLDER.
Fig. 17 Heat Shrink Tube
6. Center the heat shrink tubing over the joint and heat using a heat gun. Heat the joint until the tubing is tightly sealed and sealant comes out of both
ends of the tubing (Fig. 17).
Special Tools