Grand Cherokee 2WD V8-4.7L VIN J (2004)
5. Remove the upper and lower trim cover retainers from the airbag housing studs.
6. Disengage the horn switch feed pigtail wire connector retainer from the mounting hole in the upper trim cover retainer.
7. Remove the horn switch ground pigtail wire eyelet terminal from the upper right inflator stud on the back of the driver airbag housing.
Fig. 24 Driver Airbag Trim Cover Remove/Install
8. Disengage the four trim cover locking blocks from the lip around the outside edge of the driver airbag housing and remove the housing from the
trim cover receptacle.
ASSEMBLY
NOTE: If the horn switch and tray have been removed from the sewn pouch in the airbag cushion retaining strap, be certain that they are properly
reinstalled with the horn switch feed and ground pigtail wires properly oriented before assembling the trim cover onto the airbag housing.
1. Place the new driver airbag trim cover on a suitable work surface with the airbag receptacle facing up. Be certain to take the proper precautions to
prevent the trim cover from receiving cosmetic damage during the following procedures.
2. Carefully position the driver airbag into the trim cover receptacle. Be certain that the horn switch feed and ground pigtail wires are not pinched
between the airbag housing and the trim cover locking blocks.