Grand Cherokee 2WD V8-4.7L VIN J (2004)
Fig. 8 Airbag Control Module Connector
5. Disconnect the airbag overlay wire harness connector for the ACM from the ACM connector receptacle. To disconnect the airbag overlay wire
harness connector from the ACM:
a. Slide the red Connector Position Assurance (CPA) lock on the top of the connector toward the front of the vehicle.
b. Depress the forward edge of the CPA lock to release the connector latch tab and pull the connector straight away from the ACM connector
receptacle.
6. Disconnect the instrument panel wire harness connector for the ACM from the ACM connector receptacle.
Fig. 9 Airbag Control Module Remove/Install
7. Remove the four screws that secure the ACM to the mount that is welded onto the top of the floor panel transmission tunnel.
8. Remove the ACM from the ACM mount on the top of the floor panel transmission tunnel.
INSTALLATION
1. Carefully position the Airbag Control Module (ACM) to the mount that is welded onto the top of the floor panel transmission tunnel. The bottom
of the ACM housing is keyed. When the ACM is correctly positioned, the bottom of the housing will fit flush with the mount and the orientation
arrow on the label on top of the housing will be pointed forward in the vehicle.
2. Install and tighten the four screws that secure the ACM to the mount that is welded onto the top of the floor panel transmission tunnel. Tighten the
screws to 11 Nm (95 in. lbs.).
3. Reconnect the instrument panel wire harness connector for the ACM to the ACM connector receptacle. Be certain that the connector latch and the
red CPA lock are fully engaged.
4. Reconnect the airbag overlay wire harness connector for the ACM to the ACM connector receptacle. Be certain that the connector latch and the