Grand Cherokee 2WD V8-4.7L VIN J (2004)
3. Clean inside of windshield with Mopar Glass Cleaner and lint-free cloth.
4. Apply clear glass primer 25 mm (1 in.) wide around edge of windshield. Wipe with clean/dry lint-free cloth.
5. Apply black-out primer 25 mm (1 in.) wide on top and sides of windshield and 25 mm (1 in.) on bottom of windshield. Allow at least three
minutes drying time.
NOTE: Make sure the clear and black primers do not flow passed the black frit.
6. Position windshield spacers on lower fence above support spacers at the edge of the windshield opening (Fig. 2).
7. Apply a 16 mm (0.6 in.) high by 10 mm (0.4 in.) wide triangular bead of urethane around perimeter of windshield along the inside of the
moldings. Apply two beads along the bottom edge.
8. Install upper molding onto windshield.
9. Apply fence primer around the perimeter of the windshield opening fence. Allow at least 18 minutes drying time.
10. With aid of a helper, position windshield over windshield opening. Align reference marks at bottom of windshield to support spacers.
11. Slowly lower windshield glass to windshield opening fence. Guide top molding into proper position if necessary. Push windshield inward to fence
spacers at bottom and until top molding is flush to roof line.
12. Clean excess urethane from exterior with Mopar Super Clean or equivalent.
13. Install windshield side moldings.
14. Install cowl cover and wipers.
15. Install inside rear view mirror.
16. After urethane has cured, water test windshield to verify repair.
