Grand Cherokee 2WD V8-4.7L VIN J (2004)
wiper arm pivot ends onto the wiper pivot shafts so that the lower edge of the blade is aligned with the wiper alignment lines located in the lower
edge of the windshield glass.
2. Once the wiper blade is aligned, lift the wiper arm away from the windshield slightly to relieve the spring tension on the pivot end and push the
pivot hole on the end of the wiper arm down firmly and evenly over the wiper pivot shaft.
3. Install and tighten the nut that secures the wiper arm to the wiper pivot shaft. Tighten the nut to 24 Nm (18 ft. lbs.).
4. Wet the windshield glass, then operate the front wipers. Turn the front wipers Off, then check for the correct wiper arm position and readjust as
required.
5. Reinstall the plastic nut cap onto the wiper arm pivot nut