Grand Cherokee 2WD V8-4.7L VIN N (2000)
PDC Housing Lower Cover Remove/Install
7. Using a trim stick or another suitable wide flat-bladed tool, gently pry the latches on each side and the front of the PDC housing that secure the
housing lower cover to the PDC and remove the housing lower cover.
PDC B(+) terminal module
1. Remove the PDC housing lower cover.
PDC B(+) Terminal Module Latches
2. From the top of the PDC housing, use a small screwdriver or a terminal pick tool (Special Tool Kit 6680) to release the two latches that secure the
B(+) terminal module in the PDC.
3. Gently and evenly press the two B(+) terminal studs down through the bus bar in the PDC.