Grand Cherokee 2WD V8-4.7L VIN N (2000)
Quarter Window Glass: Service and Repair
QUARTER WINDOW
REMOVAL
1. Cut urethane bonding from around quarter window glass using a suitable sharp cold knife. A pneumatic cutting device can be used if available.
CAUTION: Care should be taken when removing the glass to avoid scratching the exterior paint surface.
2. Separate glass from vehicle.
INSTALLATION
CAUTION: Open a window before installing glass. This will avoid pressurizing the passenger compartment. If a door or liftgate is slammed
before urethane is cured, water leaks can result.
The window opening fence should be cleaned of old urethane bonding material.
1. Clean inside of glass with Mopar Glass Cleaner and lint-free cloth.
2. Apply clear PVC (vinyl) primer 25 mm (1 in.) wide around edge of glass. Wipe with clean/dry lint-free cloth.
NOTE: Make sure primer does not flow passed the black frit.
3. Apply black primer 25 mm (1 in.) wide around edge of glass. Allow at least eighteen minutes drying time.
4. Apply a 16 mm (0.6 in.) high by 10 mm (0.4 in.) wide triangular bead of urethane around window vinyl border location.
5. Position glass into window opening and lock the four clips into place.