Grand Cherokee 2WD V8-5.2L VIN Y (1998)
3.
Inspect the body side hinge half in the area shown in Figure 1. If witness marks are present indicating any wear in the area shown, hand file the
area to provide a smooth surface. Remove only enough metal to provide a smooth surface, including any burrs or metal distortion.
4.
File the corner of the door half of the hinge as shown in Figure 1 to bevel the edge and provide additional clearance to the body half of the hinge.
5.
Brush touch up the area to match and allow the paint to dry.
6.
Apply a coating of white grease to the area.
7.
Assemble the harness and install the boot over the insulator prior to installing the door.
7.
Install the door.
8.
Connect the wire harness.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
23-40-20-98
0.5 Hrs.
FAILURE CODE:
XX - Service Adjustment
