Grand Cherokee 2WD V8-5.2L VIN Y (1998)
Fig. 12 Rear Caliper Piston Dust Boot Installation
7. Seat dust boot in caliper either by hand, or with a suitable size installer tool.
8. Install caliper bleed screw, if removed.
9. Install bushing boot seals and center boot seals in the caliper.
10. Install bushings into the caliper. Be sure boot seal lips are seated in grooves at the ends of bushings.
11. Install brake shoes in caliper and install caliper.
Caliper Bracket
REMOVAL
1. Raise vehicle and remove wheel and tire assembly.
2. Remove caliper bolts and lift caliper off rotor and bracket. Suspend caliper from chassis or suspension component with wire.
3. Retract parking brake shoes and remove rotor.
4. Remove axle shaft, refer to Transmission and Drivetrain.
5. Remove parking brake shoes from splash shield.
6. Remove nuts attaching splash shield and caliper bracket to axle tube flange.
7. Remove splash shield and caliper bracket from axle studs and work lever out of rear cable eyelet.
8. Mark position of splash shield and bracket for assembly reference. Use paint or scribe to mark parts.