Grand Cherokee 2WD V8-5.2L VIN Y (1998)
7. Connect throttle body control cables.
8. Install oil dipstick mounting bolt.
9. Install idler pulley. Tighten pulley bolt to 54 Nm (40 ft. lbs.) torque.
10. Relax tension from belt tensioner. Install drive belt.
CAUTION: When installing serpentine accessory drive belt, belt must be routed correctly. If not, engine may overheat due to water pump
rotating in wrong direction. The correct belt with correct length must be used.
11. Install air duct to throttle body.
12. Install upper radiator hose to radiator.
13. Connect wiring harness to A/C compressor.
14. Connect A/C lines to clip at intake manifold.
15. Fill cooling system.
16. Start and warm the engine. Check for leaks.
