Grand Cherokee 2WD V8-5.2L VIN Y (1998)
Control Arm Bushing: Service and Repair
REMOVAL
1. Remove the upper suspension arm from axle
2. Position Spacer 7932-1 (J-35581-1), or equivalent over the bushing in the axle.
3. Install Bushing Removal/Installer.
4. Remove the bushing by tightening the Long Nut.
NOTE: On Model 30 axle, do not remove Spacer 7932-1 (J-35581-1) at this time.
INSTALLATION
1. Position new bushing, Receiver and Installer on axle.
2. Install the bushing by tightening the Long Nut.
3. Remove tools and install the upper suspension arm.