Grand Cherokee 2WD V8-5.2L VIN Y (1998)
Rear Wiper Motor Remove/Install
3. From the outside of the liftgate, remove the rear wiper motor output shaft nut.
4. Remove the external bezel and gasket from the rear wiper motor output shaft.
5. From the inside of the liftgate, remove the lift-gate inner trim panel.
6. Unplug the rear wiper motor wire harness connector.
7. Remove the screws that secure the wiper motor to the liftgate inner panel.
8. Remove the rear wiper motor from the liftgate.
9. Reverse the removal procedures to install. Tighten the mounting hardware as follows:
-
Motor mounting screws - 1.3 N.m (13 in. lbs.).
-
Wiper motor output shaft nut - 5 N.m (42 in. lbs.).