Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
(1) Remove screw attaching trim panel to inside release handle (Fig. 13).
(2) Remove screw at armrest.
(3) Remove screw at the upper mirror bezel.
(4) Using trim remover (C-4829 or equivalent), detach trim panel perimeter push-in fasteners from door inner panel.
(5) If equipped, disconnect the wiring connectors from power switch pan~.
(6) Lift trim pan~ over inside release handle and remove trim panel from door.
INSTALLATION
(1) If equipped, connect the wiring connectors to power switch panel.
(2) Position trim panel on door inner panel.
(3) Press push-in fasteners inward around perimeter of door to attach it to inner panel.
(4) Install armrest screw.
(5) Install mirror bezel screw.
(6) Install screw attaching trim panel to inside release handle.
Load Floor
LOAD FLOOR
REMOVAL
1. Remove the liftgate scuff plate, Refer to Trim Panel.
2. Remove the two nuts that secure the load floor to the floor panel.
3. Remove the load floor.
INSTALLATION
1. Position the load floor in the vehicle.
2. Install the two nuts that secure the load floor to the floor panel.
3. Install the liftgate scuff plate, Refer to Trim Panel.
A-Pillar Trim
A-PILLAR TRIM/GRAB HANDLE
REMOVAL