jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Line-A/C Discharge|Page 1257 > < Plumbing|Page 1254
Page 1
background image

Hose/Line HVAC: Service and Repair
Line-A/C Discharge

REMOVAL

WARNING:  REFER TO THE APPLICABLE WARNINGS AND CAUTIONS FOR THIS SYSTEM BEFORE PERFORMING THE
FOLLOWING OPERATION. FAILURE TO FOLLOW THE WARNINGS AND CAUTIONS COULD RESULT IN POSSIBLE PERSONAL
INJURY OR DEATH.

1. Recover the refrigerant from the refrigerant system.
2. Disconnect and isolate the negative battery cable.
3. Remove the grille.
4. Remove the air cleaner housing, air intake tube and the resonator.
5. Disconnect the wire harness connector (8) from the A/C pressure transducer (7) and remove the transducer from the A/C discharge line (5), if

required.

6. Remove the nut (6) that secures the A/C discharge line to the A/C condenser (4).
7. Disconnect the A/C discharge line from the A/C condenser and the retaining bracket (9) and remove and discard the dual plane seal.

8. Remove the nut (2) that secures the A/C discharge line (1) to the A/C compressor (4).
9. Disconnect the A/C discharge line from the A/C compressor and remove and discard the dual plane seal.

10. Install plugs in, or tape over the opened refrigerant line fittings and the compressor and condenser ports.
11. Remove the A/C discharge line from the engine compartment.

INSTALLATION

Line-A/C Discharge|Page 1257 > < Plumbing|Page 1254