Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
1. Carefully position the Occupant Classification Module (OCM) to the bracket (1) on the underside of the passenger side front seat cushion frame.
When the OCM is correctly positioned, the connector receptacles (3) on the module will be pointed forward in the vehicle.
2. Install and tighten the two screws (4) that secure the OCM to the bracket. Tighten the screws to 2 N.m (20 in. lbs.).
3. Reconnect the seat wire harness (2) connector to the OCM connector receptacle located on the outboard side of the module. Be certain that the
latch on the connector is fully engaged.
4. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed
following service of any supplemental restraint system component.
5. Following successful completion of the supplemental restraint system verification test procedure, perform the Occupant Classification System
Verification Test using a diagnostic scan tool.
