Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
Power Steering Line/Hose: Service and Repair
Pressure Line - Fan to Pump
PRESSURE LINE - FAN TO PUMP
REMOVAL
1. Siphon the power steering fluid from the reservoir.
2. Remove the pressure line at the pump.
3. Raise and support the vehicle.
4. Remove the front skid plate.
5. Disconnect the electrical connector (6) for the pressure switch (1).
6. Remove the quick connect pressure line (5) from the hydraulic cooling fan filter (2) using special tool 8875-A (3).
7. Remove the pressure line (5) from the vehicle.
8. Remove the pressure switch (1) if necessary.
INSTALLATION
1. Install the pressure line(5) to the vehicle.
2. Install the pressure line (5) at the hydraulic cooling fan filter (2).
3. Reconnect the electrical connector (6) for the pressure switch (1).
4. Install the front skid plate.
5. Lower the vehicle.
6. Install the pressure line at the pump Tighten to 28 Nm (21 ft. lbs.).
7. Fill the system with power steering fluid.
8. Bleed the DHS system using a scan tool.
