Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
1. Install the ball joint (4) into the control arm (3) and press in using special tools C-4212-F (press) (1), 9654-1 (Driver) (5) and 9654-2 (Receiver)
(2).
2. Stake the ball joint flange in four evenly spaced places around the ball joint flange, using a chisel and hammer.
3. Remove the support for the halfshaft and install into position 4X4 only.
4. Install the steering knuckle.
5. Install the tie rod end into the steering knuckle.
6. Install and tighten the halfshaft nut to 251 Nm (185 ft. lbs.). (If Equipped).
7. Install the brake caliper and rotor.
8. Install the tire and wheel assembly.
9. Check the vehicle ride height.
10. Perform a wheel alignment.
