Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
NOTE: Extreme pressure lubrication must be used on the threaded portions of the tool. This will increase the longevity of the tool and insure proper
operation during the removal and installation process.
2. Press the bushing out using special tools C-4212-F (Press) (1), 9653-1 (driver) (4) and 9653-2 (Receiver) (2) from the lower control arm (3).
INSTALLATION
STABILIZER BAR TO FRAME BUSHING
1. Install the stabilizer bar bushing (3) to the bar (1).
2. Install the stabilizer bar bushing retainer bracket (2) bolts and tighten the two mounting bolts.
3. Install the front splash shield.
4. Lower the vehicle.
CLEVIS BRACKET BUSHING
NOTE: Extreme pressure lubrication must be used on the threaded portions of the tool. This will increase the longevity of the tool and insure proper
operation during the removal and installation process.
