Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
CAUTION: The primary oil filter seal MUST be fully installed flush against the oil pump body. DO NOT install the seal onto the filter neck and
attempt to install the filter and seal as an assembly. Damage to the transmission will result.
8. Install a new primary oil filter seal in the oil pump inlet bore. Seat the seal in the bore with the butt end of a hammer, or other suitable tool.
9. Place replacement filter (1 ) in position on valve body and into the oil pump.
10. Install screw to hold filter to valve body. Tighten screw to 4.5 Nm (40 inch lbs.) torque.
11. Connect the solenoid and pressure switch assembly connector.
12. Install oil pan. Tighten pan bolts to 12 Nm (105 inch lbs.) torque.
13. Lower vehicle and fill transmission with Mopar ATF +4.
14. Check and adjust gearshift cable, if necessary.
