Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
1.
Use a trim stick to hold the tail section of the windshield molding away from the roof panel and use an alcohol wipe to clean all the way across the
vehicle between the molding and roof panel. (Fig. 1).
2.
Use a trim stick to hold the tail section of the windshield molding away from the roof panel and apply MOPAR Silicone Windshield and Glass
Sealer, p/n 04467708, in the joint between molding and the roof panel.
3.
If sealer squeeze out occurs, immediately wipe off the excess with a clean paper towel.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.
