Grand Cherokee 2WD Limited V8-4.7L (2002)
Brake Rotor/Disc: Testing and Inspection
Front Brake Rotor
DIAGNOSIS AND TESTING - FRONT DISC BRAKE ROTOR
ROTOR MINIMUM THICKNESS
Rotor minimum usable thickness is 24.5 mm (0.964 inch). Do not resurface a rotor if machining would cause thickness to fall below this limit.
Measure rotor thickness at the center of the brake shoe contact surface. Replace the rotor if worn below minimum thickness, or if refinishing would
reduce thickness below the allowable minimum.
FRONT ROTOR THICKNESS VARIATION
Variations in rotor thickness will cause pedal pulsation, noise and shudder.
Measure rotor thickness a minimum of six points around the rotor face. Position the micrometer approximately 19 mm (3/4 inch) from the rotor outer
circumference for each measurement. Thickness should not vary by more than 0.0127 mm (0.0005 inch) from point to point on the rotor. Refinish or
replace the rotor if necessary.
NOTE: Refinishing the rotor using on-car refinishing equipment is recommended.
Front rotors and hub/bearings are matched mounted for minimum lateral runout. Before removing the rotor, mark the rotor and hub/bearing to
maintain original orientation.
FRONT ROTOR LATERAL RUNOUT