Grand Cherokee 2WD Limited V8-4.7L (2002)
1. Insert the sensor through the backing plate.
2. Apply Mopar Lock N' Seal or Loctite 242 to the original sensor bolt. Use a new bolt if the original is worn or damaged.
3. Tighten the sensor bolt to 12 - 14 Nm (106 - 124 in. lbs.).
4. Secure the sensor wire in the brackets and the retainers on the rear brake lines. Verify that the sensor wire is secure and clear of the rotating
components.
5. Route the sensor wires to the rear seat area.
6. Feed the sensor wires the through floorpan access hole and seat the sensor grommets into the floorpan.
7. Remove the support and lower the vehicle.
8. Fold the rear seat and carpet forward for access to the sensor wires and connectors.
9. Connect the sensor wires to the harness connectors.
10. Reposition the carpet and fold the rear seat down.
