Grand Cherokee 2WD Limited V8-4.7L (2002)
2. Install the 10 screws that secure the two housing halves to each other. Tighten the HVAC housing screws to 2.2 Nm (20 in. lbs.).
3. Attach the wire harness electrical connector(s) to the mounts on the lower case at the blower motor end of the unit.
4. Install the 5 clips that secure the two housing halves to each other. Check doors for binding after replacement, and after assembly of housing.
5. Install the screw with plastic washer holding the lever assembly to the upper case section.
6. Install the mode door actuator on the left side of the housing.