Grand Cherokee 2WD Limited V8-4.7L (2002)
Fig.21 Power Outlet Remove/Install - Typical
3. Look inside the rear power outlet receptacle base and note the position of the rectangular retaining bosses of the mount that secures the receptacle
base to the right quarter trim panel (Fig. 21).
4. Insert a pair of external snap ring pliers into the rear power outlet receptacle base and engage the tips of the pliers with the retaining bosses of the
mount.
5. Squeeze the pliers to disengage the mount retaining bosses from the receptacle base and, using a gentle rocking motion, pull the pliers and the
receptacle base out of the mount.
6. Pull the rear power outlet receptacle base away from the right quarter trim panel far enough to access the wire harness connector.
7. Disconnect the right body wire harness connector from the rear power outlet receptacle base connector receptacle.
8. Remove the rear power outlet mount from the right quarter trim panel.
INSTALLATION
1. Align the splines on the outside of the rear power outlet receptacle base connector receptacle with the grooves on the inside of the mount.
2. Insert the rear power outlet receptacle base about half way through the mount.
3. Reconnect the right body wire harness connector to the rear power outlet receptacle base connector receptacle.
4. Insert the rear power outlet receptacle base and mount into the right quarter trim panel as a unit until the mount is seated flush against the trim
panel.
5. Press firmly on the rear power outlet receptacle base until the retaining bosses of the mount are fully engaged in their receptacles.
6. Install the protective cap into the rear power outlet receptacle base.
7. Reconnect the battery negative cable.