jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Recall - Fuel Tank Blocker Bracket|Page 3635 > < Fuel Gauge Sender|Locations|Page 3626
Page 1
background image

Technical Service Bulletin # A10

Date: 020201

Recall - Fuel Tank Blocker Bracket

February 2002

Dealer Service Instructions for:

Safety Recall No. A10 -- Fuel Tank Blocker Bracket

Effective immediately, all repairs oil involved vehicles are to be performed according to this recall notification. The labor operations for the interim
service procedure that was published in the A10 electronic mail (DMAIL) message Of January 4, 2002 will be cancelled on March 15, 2002. Those
vehicles that have already been repaired by having a skid plate installed, do NOT require any additional service.

Models

2002

(WJ) Jeep(R) Grand Cherokee

NOTE
This recall applies only to the above vehicles that are equipped with a fuel tank brush guard (WITHOUT Sales Code - XEE) built through December 13,
2001 (MDH 121317).

IMPORTANT

Some of the involved vehicles may be in dealer new vehicle inventory. Federal law requires you to stop sale and complete this recall service on these
vehicles before retail delivery. Dealers should also consider this requirement to apply to used vehicle inventory and should perform this recall on
vehicles in for service. Involved vehicles can be determined by using the DIAL VIP System.

Subject

About 71,000 of the above vehicles may not comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) 301 - Fuel System
Integrity. Under certain accident conditions, the fuel tank may deform and damage an internal control valve. This could allow fuel leakage to occur if the
vehicle rolls over. Fuel leakage in the presence of an ignition source can result in a fire.

Repair

A fuel tank blocker bracket must be installed on all involved vehicles.

Parts Information

Each dealer to whom vehicles in the recall were invoiced will receive enough Blocker Bracket Packages to service about 10% of those vehicles. Each
package contains a blocker bracket and a spacer.

Completion Reporting and Reimbursement

Claims for vehicles that have been serviced must be submitted on the DIAL System. Claims submitted will be used by DaimlerChrysler to record recall
service completions and provide dealer payments.

Use the labor operation number and time allowance shown.

Add the cost of the recall parts package plus applicable dealer allowance to your claim.

NOTE
See the Warranty Administration Manual, Recall Claim Processing Section, for complete recall claim processing instructions

Parts Return

Recall - Fuel Tank Blocker Bracket|Page 3635 > < Fuel Gauge Sender|Locations|Page 3626