Grand Cherokee 2WD Limited V8-4.7L (2002)
3.
Remove any PCMCIA card from the DRBIII(R).
4.
From the DRBIII(R) Main Menu, select Run Memory Card Program (Option 5), and then select Attempt Serial Communications (Option 1). Take
no action when the DRBIII(R) screen displays the following messages: No Memory Card Detected, Attempting Serial Communications Link,
Press Page Back To Exit.
5.
Using ISIS CD Series # 2136 or later series, reinstall or upgrade the existing Benchtop Programmer / DRBIII(R) Winflash II application on the
computer. The installation and User's guides are located on the ISIS CD under the Software Help folder for additional assistance.
6.
Launch the computer Benchtop Programmer/ DRBIII(R) Winflash II application.
7.
Click on the computer Mode menu and select DRBIII(R) Winflash. The DRBIII(R) Winflash application should display the following words in
green, DRB Connected.
8.
Either enter the ITM part number (preferred and obtained earlier), or use the following criteria to select the flash from the drop down list:
a.
Select 2002 or 2003 Model Year.
b.
Select WG Body Style.
c.
Select Engine.
NOTE:
THE PREFERRED METHOD TO SELECT THE CORRECT SOFTWARE IS BY ENTERING THE CURRENT ITM PART NUMBER
INTO THE ISIS BENCHTOP PROGRAMMER / DRBIII(R) WINFLASH II APPLICATION.
9.
Select the desired ITM Flash update (ITM02V0705 = Standalone Version of 7.05) from the table grid list on the computer.
10.
Click the Download button on the computer to send the file to the DRBIII(R).
11.
Connect the DRBIII(R) to the vehicle and select Vehicle Flash (Option 7) from the DRBIII(R) Main Menu.
12.
Carefully follow the instructions on the DRBIII(R) screen and complete the ITM reprogramming process. Power down the ITM by turning the
ignition switch to the OFF position, and disconnect the DRBIII(R) from the vehicle.
NOTE:
IF THE REPROGRAMMING SESSION FOR THE ITM HAS BEEN SUCCESSFUL, THEN IMMEDIATELY REPROGRAM THE BCM.
DO NOT START THE VEHICLE ENGINE. DO NOT ENABLE OR ARM THE VEHICLE SECURITY SYSTEM/ITM.
13.
Launch the computer Benchtop Programmer / DRBIII(R) Winflash II application.
14.
Click on the computer Mode menu and select DRBIII(R) Winflash. The DRBIII(R) Winflash application should display the following words in
green, DRB Connected.
15.
Either enter the BCM part number (preferred and obtained earlier), or use the following criteria to select the flash from the drop down list:
a.
Select 2002 or 2003 Model Year.
b.
Select WG Body Style.
c.
Select Engine.
NOTE:
THE PREFERRED METHOD TO SELECT THE CORRECT SOFTWARE IS BY ENTERING THE CURRENT BCM PART NUMBER
INTO THE ISIS BENCHTOP PROGRAMMER / DRBIII(R) WINFLASH II APPLICATION.
16.
Select the desired BCM Flash update (BCMWJGV046 = Standalone Version of 4.6) from the table grid list on the computer.
17.
Click the Download button on the computer to send the file to the DRBIII(R).
18.
Connect the DRBIII(R) to the vehicle and select Vehicle Flash (Option 7) from the DRBIII(R) Main Menu.
19.
Carefully follow the instructions on the DRBIII(R) screen and complete the BCM reprogramming process. Power down the BCM by turning the
ignition switch to the OFF position.
