Grand Cherokee 2WD Limited V8-4.7L (2002)
5. Reinstall the trim onto the right rear seat back.
6. Install and tighten the two screws that secure the belt web guide to the top of the right rear seat back panel. Tighten the screws to 2 Nm (20 in.
lbs.).
7. Reinstall the right rear seat back panel into the vehicle.
8. Restore the cargo area carpet to the base of the seat back panel and unfold the right rear seat back to its upright position.
9. Position the rear center seat belt lower anchor to the right rear seat belt buckle unit bracket on the rear floor panel.
10. Install and tighten the screw that secures the rear center seat belt lower anchor to the right rear seat belt buckle unit bracket on the rear floor panel.
Tighten the screw to 43 Nm (32 ft. lbs.).
11. Fold and latch the right rear seat cushion in its normal seating position.
Seat Belt and Retractor - Rear Outboard
REMOVAL
WARNING: DURING AND FOLLOWING ANY SEAT BELT SERVICE, CAREFULLY INSPECT ALL SEAT BELTS, BUCKLES,
MOUNTING HARDWARE, AND RETRACTORS FOR PROPER INSTALLATION, OPERATION, OR DAMAGE. REPLACE ANY
BELT THAT IS CUT, FRAYED, OR TORN. STRAIGHTEN ANY BELT THAT IS TWISTED. TIGHTEN ANY LOOSE FASTENERS.
REPLACE ANY BELT THAT HAS A DAMAGED OR INOPERATIVE BUCKLE OR RETRACTOR. REPLACE ANY BELT THAT HAS
A BENT OR DAMAGED LATCH PLATE OR ANCHOR PLATE. NEVER ATTEMPT TO REPAIR A SEAT BELT COMPONENT.
ALWAYS REPLACE DAMAGED OR FAULTY SEAT BELT COMPONENTS WITH THE CORRECT, NEW AND UNUSED
REPLACEMENT PARTS LISTED IN THE MOPAR PARTS CATALOG.
1. Disengage the rear seat cushion latch by pulling upward on the release strap.
2. Fold the rear seat cushion forward against the back of the front bucket seat.
Fig.36 Rear Outboard Seat Belt & Retractor Remove/Install
3. Remove the screw that secures the rear outboard seat belt lower anchor to the rear floor panel.
4. Remove the lower anchor from the rear floor panel.
