Grand Cherokee 2WD Limited V8-4.7L (2002)
2. Install and tighten the two screws that secure the right or left side impact sensor to the B-pillar. Tighten the screws to 12 Nm (105 in. lbs.).
3. Reconnect the airbag overlay wire harness connector for the right or left side impact sensor to the sensor connector receptacle.
4. Reinstall the trim onto the lower right or left B-pillar.
5. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed
following service of any supplemental restraint system component. (Refer to ELECTRICAL/RESTRAINTS - STANDARD PROCEDURE -
VERIFICATION TEST).
