Grand Cherokee 2WD Limited V8-4.7L (2002)
Fig.19 Right Multi-Function Switch Remove/Install
5. Remove the two screws that secure the right multi-function switch to the multi-function switch mounting housing.
6. Remove the right multi-function switch from the multi-function switch mounting housing.
INSTALLATION
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY
STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT
AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM
CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO
DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG
DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
1. Position the right multi-function switch onto the multi-function switch mounting housing.
2. Install and tighten the two screws that secure the right multi-function switch to the multi-function switch mounting housing. Tighten the screws to
2.5 Nm (22 in. lbs.).
3. Reconnect the instrument panel wire harness connector for the right multi-function switch to the switch connector receptacle.
4. Position the lower tilting steering column shroud to the underside of the steering column.
5. Install and tighten the screw that secures the lower tilting steering column shroud to the multi-function switch mounting housing. Tighten the screw
to 1.9 Nm (17 in. lbs.).
6. Position the upper tilting column shroud over the steering column with the hazard warning switch button inserted through the hole in the upper
surface of the shroud. Align the upper tilting steering column shroud to the lower shroud and snap the two shroud halves together
7. Reconnect the battery negative cable.
