Grand Cherokee 2WD Limited V8-4.7L (2002)
Windshield Washer Spray Nozzle: Service and Repair
Rear
REMOVAL
The check valve for the rear washer nozzle is integral to the nozzle.
1. Using a trim stick or another suitable wide flat-bladed tool, gently pry at the sides of the rear washer nozzle to release the snap features that secure
it in the mounting hole of the liftgate outer panel.
Fig.4 Rear Washer Nozzle Remove/Install
2. Pull the rear washer nozzle out from the liftgate outer panel far enough to access the washer supply hose.
3. Disconnect the washer supply hose from the barbed nipple of the rear washer nozzle.
4. Remove the rear washer nozzle from the liftgate.
INSTALLATION
1. Position the rear washer nozzle to the liftgate.
2. Reconnect the washer supply hose to the barbed nipple of the rear washer nozzle.
3. Insert the rear washer nozzle supply hose and nipple into the mounting hole in the liftgate outer panel.
4. Using hand pressure, push firmly and evenly on the rear washer nozzle until the snap features lock into place on the inside of the liftgate outer
panel mounting hole.
