Grand Cherokee 4WD V8-4.7L (2003)
INSTALLATION
WARNING: REVIEW ALL WARNINGS AND CAUTIONS BEFORE PRECEDING WITH INSTALLATION.
CAUTION: Open a window before installing windshield. This will avoid pressurizing the passenger compartment. If a door or liftgate is
slammed before urethane is cured, water leaks can result.
The windshield fence should be cleaned of old urethane bonding material. Support spacers should be cleaned and properly installed on weld studs or
repair screws at bottom of windshield opening.
Fig. 4
1. Place replacement windshield into windshield opening. Position glass in the center of the opening against the support spacers. Mark the glass at the
support spacers with a grease pencil or masking tape and ink pen to use as a reference for installation. Remove replacement windshield from
windshield opening (Fig. 4).
Fig. 5
2. Position the windshield inside up on a suitable work surface with two padded, wood 10 cm by 10 cm by 50 cm (4 in. by 4 in. by 20 in.) blocks,
placed parallel 75 cm (2.5 ft.) apart (Fig. 5).