Grand Cherokee 4WD V8-4.7L VIN N (2000)
1. Insert sensor through the backing plate.
2. Apply Mopar Lock N' Seal or Loctite(TM) 242 to original sensor bolt. Use new bolt if original is worn or damaged.
3. Tighten sensor bolt to 12 - 14 Nm (106 - 124 inch lbs.).
4. Secure sensor wire in brackets and in retainers on rear brake lines. Verify that sensor wire is secure and clear of rotating components.
5. Route sensor wires to rear seat area.
6. Feed sensor wires through floorpan access hole and seat sensor grommets in floorpan.
7. Remove support and lower the vehicle.
8. Fold rear seat and carpet forward for access to sensor wires and connectors.
9. Connect sensor wires to harness connectors.
10. Reposition carpet and fold rear seat down.
