Grand Cherokee 4WD V8-5.2L VIN Y (1998)
Door Sensor/Switch (For Alarm): Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
Door Ajar Switch
2. Remove the screw that secures the door ajar switch to the pillar at the rear of the door opening.
3. Pull the switch out from the mounting hole in the door opening far enough to access the wire harness connector.
4. Unplug the wire harness connector from the switch.
5. Reverse the removal procedures to install. Tighten the switch mounting screw to 1.7 N.m (15 in. lbs.).
