Grand Cherokee 4WD V8-5.7L (2008)
Parking Brake Pedal: Service and Repair
Installation
Non-Adjustable Pedal
NON-ADJUSTABLE PEDAL
1. Install the pedal assembly to the vehicle.
2. Tighten the upper brake pedal sled nuts.
3. Install the lower steering shaft to the column.
4. Install the lower steering shaft pinch bolt at the column.
5. Unlock the steering wheel.
6. Install the 2 intermediate shaft bearing nuts (1).
7. Install the power brake booster See: Power Brake Assist/Vacuum Brake Booster/Service and Repair/Power Brake Booster - Installation.
8. Install booster push rod (2) on pedal pin (3) and install retainer clip (1) on pedal pin.
9. Reconnect the negative battery cable.
10. Fill and bleed brake system.
11. Check and adjust stop lamp switch if necessary.
Adjustable Pedal
ADJUSTABLE PEDAL